Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Winston-Salem?
Spring repair in Winston-Salem typically costs $180 – $340 for one spring, and most homes here have a matched pair that’s usually replaced together, so a full pair runs about twice that. That estimated range covers the spring itself plus the labor to wind, balance, and test the door. The written estimate sets the final price, and we give that estimate for free before any work begins.
Winston-Salem homeowners call us most often about a snapped spring because the door simply won’t lift, or it lifts a few inches and stops. That’s the spring doing its job by failing safe. The numbers below show what replacement usually looks like in this market, what pushes the cost up or down, and how to keep the bill at the low end of the range.
Spring Replacement Cost Breakdown (2026)
Here’s how spring-related work breaks down for the Winston-Salem market. These are typical estimated ranges for 2026, not quotes for your specific door.
| Work | Typical Estimated Range |
|---|---|
| Spring repair (one spring) | $180 – $340 |
| Spring replacement (matched pair) | about twice the one-spring range |
| Cable repair | $130 – $250 |
| Roller replacement | $110 – $220 |
| Track realignment | $120 – $240 |
| Panel replacement | $250 – $500 |
| Opener repair | $120 – $320 |
| Opener installation | $250 – $550 |
| New door installation | $700 – $2,200 |
| General garage door repair | $150 – $600 |
Notice how the spring sits near the bottom of the general repair range. Springs are one of the least expensive parts on the door and one of the most consequential. The cost of a spring job comes down to four things: the spring type (torsion or extension), the wire gauge and cycle life of the replacement, whether one spring or a pair is being swapped, and whether anything else got damaged when the spring let go. A clean spring swap on a healthy door sits low in the range. A spring that failed and dragged a cable, bent a track, or knocked a roller loose pushes the job toward the top, because we’re now fixing more than one thing.
What Affects Spring Replacement Pricing in Winston-Salem
- Spring type. Torsion springs, the ones mounted on a shaft above the door, are the standard on most single- and double-car doors in Winston-Salem. Extension springs, mounted along the sides, show up on older and lighter doors and price differently. A torsion spring has to be wound to a specific tension, which adds setup time.
- Cycle life of the replacement. Springs are rated by how many open-and-close cycles they’ll take. A higher-cycle spring costs more up front but lasts longer. On a high-use door, like one a household opens several times a day, spending a little more on the spring itself usually pays back over time.
- One spring or a pair. If both springs are worn, replacing them together is almost always the right call, since the second is usually close behind the first. A pair costs about twice a single spring, which is still cheaper than two separate service visits.
- Door weight and size. A wide double-car door with heavier panels needs stronger springs than a single-car door. Heavier springs, and the extra care to balance a big door, land the job higher in the range.
- What the failure took with it. A snapped spring can send the door down hard or leave the cables slack, and the impact sometimes bends a track or a panel. Each of those is a separate line item, which is why a spring call with collateral damage climbs toward the general repair range.
- Brand of door and matching hardware. We work on the brand you already have, whether that’s Clopay, Amarr, Wayne Dalton, Raynor, or another. Familiarity with the door and its hardware means fewer surprises on the estimate and fewer trips to get it right.
How to Save on Spring Replacement
The biggest saving isn’t a coupon, it’s catching the spring before it fails and takes other parts with it. Springs rarely break without warning. If the door starts feeling heavier than usual, loses its smooth lift, or you hear a creak that wasn’t there before, that’s worth a look, and an inspection is cheaper than a spring plus a cable plus a track.
- Replace the pair together. If one spring has failed, the other is usually on the same clock. A matched pair costs about twice a single spring, but doing them together avoids a second service call a few months out.
- Ask for the higher-cycle spring. Paying a little more for a longer-wearing spring means you’re not back at the same job sooner. Over the life of the door it’s the cheaper path.
- Fix the small stuff before it grows. Worn rollers and slightly off tracks are inexpensive on their own and can wear a new spring faster. Handling them in the same visit usually beats paying for a separate trip later.
- Get the free written estimate first. Every job starts with a free estimate, so you know the price before anyone touches the door. The written estimate sets the final price. Call (877) 692-2814 to book one.
We handle the whole door system: the springs, cables, rollers, tracks, and panels, plus the opener and drive mechanism. If your spring failure turns out to have a related opener problem, you don’t coordinate a second contractor. One call covers the whole door.
The Brand on Your Door Doesn’t Limit Who Can Fix It
Plenty of Winston-Salem doors carry the name of a single manufacturer, and some homeowners assume they have to go back to that brand for a spring. You don’t. Our technicians are trained and experienced on eight of the widely installed brands in North America: LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. Whether your opener is a LiftMaster or a Genie, our technicians know the system and the door it’s lifting. That brand-agnostic approach means we diagnose based on what’s actually wrong with your door, not on which products we’re set up to sell.
We read the problem first, then fix it. A spring that’s three inches off the ceiling gets replaced with one sized for your door, not with a one-size part. From the opener motor to the bottom seal, the goal is a door that runs quietly and safely when we leave. That’s what the Crescent name is meant to signal: careful, methodical work rather than rushed volume.
Can I Repair My Own Spring?
No. Garage door springs are under serious tension, and a torsion spring, once wound, holds enough stored force to cause grave injury if it releases unexpectedly. Extension springs carry similar risk. This is the one part of the door system we tell homeowners not to touch. There is no safe do-it-yourself version of winding a spring, and we won’t describe steps for it. A trained technician brings the right winding bars, the right spring, and the experience to release tension safely. Leave it to a professional. That’s the honest advice, not a sales pitch.
What you can do safely is look, not touch. You can visually check whether a torsion spring looks broken or has a visible gap, listen for a rattle, and notice whether the door lifts evenly. If anything looks or sounds off, call us and we’ll take it from there.
What Else Often Comes Up with Spring Replacement
When we get a spring call in Winston-Salem, roughly half the time the owner mentions a second issue once we’re on site. Cables and rollers are the most common pairing. A cable that’s also failing is a $130 – $250 job, and a worn set of rollers runs $110 – $220. Track realignment sits at $120 – $240 if the door has shifted or a track has taken a hit. And if the opener is straining because it’s been dragging a heavy door, opener repair runs $120 – $320.
If your door has reached the end of its life, a new installation ranges $700 – $2,200 depending on door size and style. A single panel replacement is $250 – $500 if the rest of the door is sound. The written estimate always spells out what’s being done, so you can decide what to fix now and what can wait.
What Happens When You Call
Call and we’ll ask a few quick questions: single or double door, torsion or extension springs, what happened when it broke. From there we book a visit. We answer 24/7, and dispatch runs 7am – 7pm, Sunday through Friday. We’re closed Saturday. A call outside dispatch hours is booked into the next opening.
The estimate itself is free. A technician looks at the door, explains what’s wrong, gives you the written price, and gets your approval before anything happens. No surprise charges, no pressure. If it’s a straightforward spring swap, we can usually sort it in a single visit.
FAQs – Spring Replacement Cost in Winston-Salem
How much does it cost to replace a garage door spring in Winston-Salem?
Replacing one spring in Winston-Salem typically costs $180 – $340. Because most doors here use a matched pair, replacing both springs runs about twice that range. The written estimate sets the exact price. Call (877) 692-2814 for a free quote.
Is it cheaper to repair or replace a garage door spring?
Repair – replacing the spring itself – is the cheaper option, and at $180 – $340 per spring it’s far less than a new door at $700 – $2,200. A spring is a part, not the whole door, so replacement of the spring is the normal fix. Only if the door’s panels, tracks, and hardware are all worn would a new install make sense. Our free estimate tells you which way to go. Call (877) 692-2814 to book one.
Can you come today if my spring broke?
Often, yes. A broken spring leaves the door unusable, so we prioritize those calls and work to fit them in the same day. We answer 24/7, and dispatch runs 7am – 7pm, Sunday through Friday. Call (877) 692-2814 and we’ll tell you the soonest opening.
How long do replacement springs last?
It depends on the cycle rating of the spring, which is not a number we can give you for your specific door without seeing it. What we can say is that higher-cycle springs last longer than standard ones, and a door that opens several times a day wears through springs faster than one used once or twice. Ask about the cycle life when you get your estimate, and choose the spring that matches your use. Call (877) 692-2814 to talk through it.
Do you charge extra for a pair of springs?
A pair costs about twice a single spring, which is the normal price, not a surcharge. Because springs wear on the same schedule, replacing both at once usually saves a second service call later. If only one spring failed and the other is still fresh, a single spring replacement is fine. The estimate will show you both options. Call (877) 692-2814 for a free estimate.
Spring Replacement for Your Door, at a Fair Estimate
A broken spring stops your whole day, and we know it. That’s why we get to the point: a clear price range up front, a free written estimate on site, and work done by technicians with up to experience on the eight major brands. We cover the full door system, so if the spring failure turns out to involve the opener, the cables, or a panel, you’re not chasing a second contractor. You’ll find the full range of what we do and how Winston-Salem homeowners reach us on our Crescent Garage Door Repair page and our Winston-Salem page.
Call (877) 692-2814 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Winston-Salem market as of 2026. Crescent Garage Door Repair offers free estimates – call (877) 692-2814.
What Our Customers Say
"The old chain drive sounded like a freight train through the bedroom above the garage. Went with the belt drive they recommended and now I genuinely cannot hear it open from upstairs."
- Lisa Ackerman"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Tim Novak"Keypad stopped working, which I assumed meant a whole new system. It was the batteries and a reprogram. He charged me the minimum service call and told me how to do it myself next time."
- Michael Meyer